• Online only

LED power supply | Alu | 12V | 100W | IP67

zł121.94
Shipment in 1-2 business days
LED Power Supply
zas_12_100_al_bo
Led power supply key features: 12V output, 100W power, IP67 rating, aluminium design. Read the full specs below and choose the best fit. Add to cart with confidence.

Look also at our: LED strips | Other LED Power Supplies | LED Drivers & Controllers

Quantity
  Delivery

1-3 dni (PL), 3-10 dni (non-PL)

 

Privacy Policy

  Return Policy

14 days

LED power supply - choose the right one for Your project.

LED power supply parameters 12V DC and 100W headroom for demanding loads. The aluminium housing improves heat dissipation and robustness. With IP67 sealing, it resists dust and temporary immersion. Typical uses include outdoor signage, garden and facade lighting, and damp or dusty areas. It brings stable output, low ripple, and premium build quality.

Protections built into the led power supply

  • Over-voltage protection (OVP) shields LEDs from spikes.
  • Over-current protection (OCP) prevents overload damage.
  • Short-circuit protection (SCP) auto-recovers after faults.
  • Over-temperature protection (OTP) limits heat-related failures.
  • EMI filtering and, where applicable, active PFC for cleaner power.

When to use power injection

Long LED strips drop voltage along the run. Brightness fades and colors shift. Use power injection by feeding 12V at multiple points. Plan feeds every 5 m for 12 V tape, or sooner at high power. Calculate current, size cables properly, and ground all returns. Combine this with a 12v 100w power supply to keep uniform light across every segment.

Sizing your power supply

Sum the LED load and add a 20–30% margin. This protects lifespan and thermal performance. Match polarity, check ambient temperature, and allow airflow. For sealed installs, derate output. Use the aluminium led psu only where it adds value, and pick certified units for safety.

FAQ — Your questions answered

Q: Can I run several strips in parallel?
A: Yes, if total current stays within the limit and each branch is fused.

Q: Why does my strip dim at the end?
A: Voltage drop. Add power injection and use thicker supply cables.

Choose cables with low resistance, avoid sharp bends, and double-check polarity before power-up. Test sections incrementally to catch wiring errors early.

Ready to build? Order today for premium performance and dependable light.

Look also at our: LED strips | Other LED Power Supplies | LED Drivers & Controllers

zas_12_100_al_bo

Data sheet

Power supply type
Constant Voltage 12V,24V,... (CV)
Rated power
100W
Rated power
61 - 100W
No. of outputs
1
Grounding
No
Way/protocol of dimming
N/A
Dimensions (L x W x H) [mm]
210/70/40
IP grade
IP67
Mounting way
Double side adhesive tape (not included)
Mounting way
Screwed (screws not included)
Mounting way
Many ways:
Mounting way
Loose (no tension on the cables)
Input voltage
AC 185V - 230V
Output Voltage (CV)
12V
Maximum outpud current of led driver (CV)
8,3A
Case type of power supply
Waterproof
Case type of power supply
Isolated / secured
Case material
Aluminium
Interface
Integrated input and output cable
Warranty
1 year

Related products

(There are 16 other products in the same category)